Using Cisco Packet Tracer, Firstly, These are the 4 different network topologies That we will use: 1-Star. 2-Bus. 3-Half-mesh. 4-Full-mesh. Secondly, create these topologies on cisco packet tracer where each topology consists of four end-devices (such as PC, Laptop, Printer) and four switches (2960). Use the following router (PT-EMPTY) to connect the whole topologies, you should add the Giga-Ethernet module for your router. Thirdly, Assign the end-devices and switches a valid IP address, Subnet mask, and default getaway. Do not forget to configure the router with appropriate IP. Each topology should have different IP class, you may duplicate any class twice only. Fourthly, fill the following table based on your work: Device Interface IP Address Subnet Mask Default Gateway Router0 PC0 Switch0 | Anime